Yellow Bullet Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
92 Posts
Discussion Starter #1
Guys im on need of head gaskets to finish my motor.

SBF 4.205 bore .060

Anyone have some on hand ?

Or know a place that can make them ?

Ordered Cometic in March, still no gaskets and wont give a eta..

thanks.
 

·
Registered
Joined
·
6,148 Posts
Ed Curtis at FlowTech Induction has a lot of those specialty parts that are key in putting a good engine together. He has filtered out a lot of the crap. As for the thickness, he shows up to 0.051" in the Cometic line, and up to 4.200" bore size. A shout out to him might prove helpful.


 

·
Registered
Joined
·
92 Posts
Discussion Starter #3
Ed Curtis at FlowTech Induction has a lot of those specialty parts that are key in putting a good engine together. He has filtered out a lot of the crap. As for the thickness, he shows up to 0.051" in the Cometic line, and up to 4.200" bore size. A shout out to him might prove helpful.



Yea i talked to Ed yesterday... no luck .
 
1 - 3 of 3 Posts
Top