Yellow Bullet Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
97 Posts
Discussion Starter #1
I always turn the key on and let all my gauges do a full sweep before starting the engine. Lately my Innovate a/f gauge won't read after the normal engine run time and letting the o2 sensor heat up. After the initial start of it not working, I shut the engine off, restart it and it works fine. Any ideas?
 

·
Registered
Joined
·
49 Posts
You can hook a laptop to the wideband and let the Innovate software show you what's going on with the wideband; if it's in an error condition or just in warm up. From your description, it sounds like it's just in warm up.
 
1 - 3 of 3 Posts
Top