Yellow Bullet Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
30,066 Posts
They don't have part numbers on them. There are two sets of mounting holes on the rear/backside of the manifold. The closest ones are approx 9 5/8" apart, they would be for the 142/144. the second set is approx 10 3/4" apart they are for the 162 (yes that is right) and the 174/177 I do have a couple set's of gaskets that I measured to get those dimensions.

I had all the specs before (on old computer) but they are all determined on case length. 144 was the smallest, 162 (pre 80's first one built) than 174 is the longest. Those were single carbs, then the 250's were dual carbs.

Hope that helps. I'm going off of Chevystuff I had, not sure about a Ford manifold.
 
1 - 1 of 1 Posts
Top