[debacle-racing]

this may be a dumb question, and its probably been covered a zillion times, but, how is it calculated?

 

[rb69]

Use a tape measure & this link should get you going .http://inductionmotorsports.com/im/

 

[Warrant]

Way too much information here. http://home.earthlink.net/~whshope/

 

[debacle-racing]

ok, its official, im fucking stupid.
how is it calculated with caltracs? the same way? does anyone have any drawings of how to find the i.c. with caltracs?

 

[LSXS10]

I was just looking thru there and was wondering the same thing...

 

[debacle-racing]

ANYONE?

 

[debacle-racing]

ttt

 

[quarterstang86]

I've done it the old school way, plotting it out on the floor. Always taken the measurements the same way as the first link states. Kinda takes you back to school a little bit but worth understanding about your vehicle.

 

[debacle-racing]

ok, so you you use the front spring eye as the top control arm and the bolt for the transfer link as the bottom control arm?
any help here would be great.

 

[quarterstang86]

oooof - leaf springs are not in my book yet, all in due time. So with that said, take a look at the link I found below. Makes good sense.

http://www.dragstuff.com/forum/viewtopic.php?f=1&t=36&view=next

 

[debacle-racing]

ok, i roughly know where it is, where should it be?