[rockin jester]

Data log is triggered off of the TPS. Set to activate at 70% TPS to start reading during the burn out. Data log after the pass only shows I am at 70% TPS while at full throttle. Did a TPS Auto reset and it reads 100% but only shows 70% on data log. Weird...

 

[rockin jester]

103 views with no opinions.

 

[rick90lx]

I've never seen that on my datalogs, I activate at 50% for 90 seconds and it always shows my tps from activation to 100%.

 

[Glenn.Payne]

No help with your TPS but try just activating from transbrake no TPS input. I've had best results that way getting complete and to the point logs.

 

[rockin jester]

I'll make the change to the button and see if that curea the glitch. Thank you.

 

[boostedbowtie]

if you use the trans brake button to start the log , will it log for the set "max log time " even though the trigger loses the 12 volt signal when the brake is released.

 

[Mike Beck]

if you use the trans brake button to start the log , will it log for the set "max log time " even though the trigger loses the 12 volt signal when the brake is released.

Yes.

 

[boostedbowtie]

Thanks Mike .

Always used TPS , but would rather use TB .