Yellow Bullet Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
305 Posts
Discussion Starter #1
Hooked up my Iq3 Dash and I'm not getting any readings from the Holley. I configured the Holley Can bus 1 to Racepak and still don't get anything. haven't hooked up the racepak to my laptop to configure the settings yet as I needed to buy a serial to usb adapter. Would that have anything to do with it? I`m also wondering if the cables themselves have anything to do with the Holley not reading the iq3. I currently have the straight cable into the back of the iq3.
 

·
Registered
Joined
·
146 Posts
You'll need to program all the inputs that you aant to display. I belive the instructions outline this. Good luck
 
1 - 4 of 4 Posts
Top