Yellow Bullet Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1 (Edited)
Have a friend with a pulling Truck. Around 6-700hp full roller stock crank H-beam rods running 9 quarts oil turning 8000 rpm.
This is the second build that has wipped out Number 7 and 8 rods and burning up number 4 main. This will happen in about 8 runs on the track. This last time threw #8 rod out side of block.
Whats the best way to ensure good oil is getting to back of crank? bearing clearance is good.

thanks for any help!
 
1 - 1 of 1 Posts
Top