Yellow Bullet Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,187 Posts
Discussion Starter · #1 ·
i have a set of brodix spread port heads going on my sbc. my question is, what is the best(cheapest) way to do my headers? i don't want to spend 800 bucks on a set from kooks. i don't mind to fabricate some(build my own plates) ut then i still have to buy a spreadport header to match up, or cut and spread the tubes in the middle apart right? if anyone has any tips or headers laying around let me know. thanks. its goingin a stock frontend stock susp 68 camaro also. thanks
 

·
Banned
Joined
·
71,969 Posts
If you want to save money, you will need to do all the fab work yourself. That's 80% in the cost of a set of custom headers anyway.

You can take a reg set and cut them up to fit the spread port exhausts once you get the correct flanges. Will take some effort though and good welding skills.
 
1 - 2 of 2 Posts
Top