Yellow Bullet Forums banner
1 - 1 of 11 Posts

· Registered
1,339 Posts
Factory was 7/16". I sure hope you are using 1/2" minimum. You can call Moser about getting your axles threaded for 5/8" which is a very good idea. Some machine shops are better than others, and there is no room for "good enough" here. My Moser 35s came with both threaded patterns.
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.