Yellow Bullet Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
151 Posts
Discussion Starter · #1 ·
I'm in the process of a doing a K Member swap on a 91 mustang and it's all going according to plan, given the circumstances of having only hand tools.

In any case, the castle nut that connects the lower control arm to the spindle is essentially seized.

I'm on the fence about just buying new spindles since I am going to replace the upper control arms as well. If that were the case, theoretically, could I just drop it all out, and bolt up the new stuff and then swap the brakes and wheels over?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top