I have run a 15X10 w 6.5 bs w a 28x10.5 with a little hammer mechanics on the inner wheel well in the front.
FOX body wheel tubs ???
I tried to do a search; but had no luck. Will a 28 X 10.5 E.T. Drag fit into the factory wheel well without minitubbing? If so; what offset with a 15 X 9 " wheel ( if it will work) will work with stock width 8.8" rear?
Also; can 84' 4-lug rotors be drilled out to 4 3/4" 5-lug GM bolt pattern? O r does someone make them? Reason I'm wondering is because I've already got 15 X 3.5 Alumastars for GM bolt pattern and would like to use them if possible.
Appreciate your time. Thanks.
Also; can 84' 4-lug rotors be drilled out to 4 3/4" 5-lug GM bolt pattern? O r does someone make them? Reason I'm wondering is because I've already got 15 X 3.5 Alumastars for GM bolt pattern and would like to use them if possible.
Appreciate your time. Thanks.
1 - 6 of 6 Posts
I had a 28x10.5 on a 15x8 with 5.5bs and I had to roll the outer fender lip and beat the inner fender a little to make them fit. I now have 28x10 goodyears on it now.
fit in? no fit the car yes. i had them on my car with the wheel well beat to hell and the car was kind of stink bugged. but you can get them on there and they will work
just get the BFH
just get the BFH
LOL. That doesn't sound good; I was hoping to keep the car at a fairly low stance. Was yours with 28" tires?fit in? no fit the car yes. i had them on my car with the wheel well beat to hell and the car was kind of stink bugged. but you can get them on there and they will work
just get the BFH
1 - 6 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Yellow Bullet Forums
A forum community dedicated to drag racing drivers and enthusiasts. Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!
Full Forum Listing
Recommended Communities
