Yellow Bullet Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,858 Posts
Discussion Starter #1
I have read lots about feed line sizing.I want to know about the size of the line that runs from the showerhead to each side of the fogger.If you run a 400 hit then it would be 200 to each side of the motor.What can #4 line feed to 4 nozzels.Trying to make room on the intake.The main line will be #8 with 2 bottles feeding it.
 

·
Super Moderator
Joined
·
12,175 Posts
Long story short... If your spraying it that hard using -6 lines will help the system make a little more power. The smaller the lines, the greater the pressure drops..

Maybe look at it like this, if your going to feed the two solenoids with a -4 why not feed your "Y" with just a -6 then ??

My point I guess is, if your going to a -8 supply, go to -6 to the solenoids to get all the benifits of these changes you can.. Thanks, SJ
 

·
Registered
Joined
·
2,858 Posts
Discussion Starter #4
Thanks.I guess the best way is #6.We need taller intakes to make more room for this stuff.
 
1 - 4 of 4 Posts
Top