Yellow Bullet Forums banner

1 - 9 of 9 Posts

·
UP ON JACK STANDS
Joined
·
4,090 Posts
Discussion Starter #1
I am looking to buy a set of flare punches for making tapered holes in sheetmetal like you would see in a bomber seat or race car. Most of them are $600 a set. I was wondering if there is someplace that sells them cheaper. I did not want to pay $600 bucks for them when they will only get used once in a while. Even a used set would be good.
 

·
Registered
Joined
·
41 Posts
pm sent.
I am looking to buy a set of flare punches for making tapered holes in sheetmetal like you would see in a bomber seat or race car. Most of them are $600 a set. I was wondering if there is someplace that sells them cheaper. I did not want to pay $600 bucks for them when they will only get used once in a while. Even a used set would be good.
 

·
UP ON JACK STANDS
Joined
·
4,090 Posts
Discussion Starter #9
I picked up a small set from Dagger Tools when I was at Carlisle. It's funny you should mention the bolts, they gave me an extra one for each die set.
 
1 - 9 of 9 Posts
Top