Yellow Bullet Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2,410 Posts
Discussion Starter #1
Was wondering if anyone would know if the 1st generation of the holley dominator would work on the ford 4.6 using the v3 software.
 

·
Registered
Joined
·
2,452 Posts
Well, the problem isn't with the V3 software/firmware, since it's for every ECU ever made (according to Holley Tech). The problem is with the later internal ECU hardware that's optimized for the Ford Modular & Chrysler Hemi engines:
http://documents.holley.com/199r10724rev1.pdf (Read center of page 3.)
 
1 - 3 of 3 Posts
Top