Yellow Bullet Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
7,854 Posts
You could pull a couple of the valve springs (with the piston at TDC) and move the valve back/forth to see if the guides are loose. Valve has to be off the seat a little though. If they are they'll probably start wiping out your valve job if left unchecked. Is your rocker geometry correct (ie in relation to the valve tip)?

Craig
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top