Yellow Bullet Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,681 Posts
I asked a similar question a couple of months ago and what I was told is this. An acceptable piston rock and piston to head clearance is based off of piston material/compression surface design, rod manufacturer, bore diameter, valve angle, and combustion chamber design. What I took away from that was, there isn't a defining answer on what is ok.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top