Yellow Bullet Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
228 Posts
Discussion Starter #1
Does anyone sell heim[spelling] joints with extra lenth on the threads.
 

·
Registered
Joined
·
4,629 Posts
I have seen some but they were specialty application, I dont know if they would be available for sale..

Call Rod End Supply 1-800-284-2902
 

·
Registered
Joined
·
228 Posts
Discussion Starter #7
Hanging the heim out isn't a good idea in some areas.
I understand. If I have to lower my ladder bar to the bottom hole, my top rear joint may screw out a little further than I would feel comfortable. I would still have about 1.5 times the diameter of threads inside the ladder bar tubing. Would this be enough. 3000# car, 650hp. Just looking for added insurance.:smt102
 

·
Registered
Joined
·
4,629 Posts
I understand. If I have to lower my ladder bar to the bottom hole, my top rear joint may screw out a little further than I would feel comfortable. I would still have about 1.5 times the diameter of threads inside the ladder bar tubing. Would this be enough. 3000# car, 650hp. Just looking for added insurance.:smt102
On that position with 1.5 times the diameter you will be fine.
 
1 - 9 of 9 Posts
Top