Yellow Bullet Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5,404 Posts
Is there a reason that you have your RPM-1 switch on your WOT switch? That unit will not shift until the set point is reached so let it have power all the time. This will also isolate it from the nitrous solenoids and avoid any spike in voltage.
Do you run a MSD 2 step or 3 step rpm control?
 

·
Registered
Joined
·
5,404 Posts
It was the way I read it but it's all good.
Some things to double check.
a. All connections are tight and more importantly have good gound.
b. If you have a good multi-meter check the current load and make sure you have big enough gage wire to handle it. Long runs on small gage = voltage drop.
c. Try a run without the NOS powered, this way you can isolate some things.
d. If it still happens check cap, rotor, plug wires for arcing.
e. voltage during a run, I am not sure about the Biondo box but MDS told me things get crazy if voltage drops under 11 vdc.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top