Yellow Bullet Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
3,139 Posts
Discussion Starter #1
Anyine buy an Edelbrock 2917 Lately. What did you think of the CNC work???

Keith
 

·
Registered
Joined
·
1,067 Posts
well if it's anything like the small block one (2825), then save your cash. definitely not worth it. send it to bryce or chad or someone who knows what the f they're doing.
 

·
Registered
Joined
·
3,139 Posts
Discussion Starter #3
It's all ready on the way back to the warehouse. When I asked PBM, where I bought it from they acted like they never had a complaint about them. I also called R&M and asked them and I was told that is the way they look. I just wanted to make sure I wasn't being to critical. They are $300 more money then a 2927. I could never sell something that looked like that to a customer.


Keith
 

·
Registered
Joined
·
3,139 Posts
Discussion Starter #4
 

·
Registered
Joined
·
3,139 Posts
Discussion Starter #5
 

·
Registered
Joined
·
1,781 Posts
Geez!
 
1 - 8 of 8 Posts
Top