Yellow Bullet Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
261 Posts
Discussion Starter #1
I have a car in the shop and I expect the tailshaft/driveshaft is too long.

The tranny rear seal to diff yoke center measures 61.41” (1560 milimeters)

How do I calculate what length the tailshaft must be from center to center on the universals?

They are a 1350 Uni with a strange slip yoke to suit a Glide.
 

·
Registered
Joined
·
5,040 Posts
Put the yoke in the trans until it bottoms and pull it out 1". Measure from center of u-joint on yoke to center on pinion yoke. Of course this is with the car sitting on it's tires on boxes or a ramp lift or trailer.
 
1 - 2 of 2 Posts
Top