Yellow Bullet Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
121 Posts
Discussion Starter #1
I bought a 454 for a couple hundred dollar.Didnt know anything about it but saw forged sealed power in the short block.Still had the pan on it so didn't see anything else.When I took it apart it had a h-beam rod and the sealed power pistons didn't have provisions for a spiral lock.They had a wristpin that would float but had some kind of aluminum slugs on the end of the wrist pins.They aren't locked in by any kind of lock just look like the cylinder wall keeps them from coming out.My question would be is this any good and can you put any power to a setup like this.Im planning on boosting it to 550-600hp and just haven't seen this kind of setup before..Opinion are welcome..thanks in advance
 

·
Shrewd Negotiator
Joined
·
10,415 Posts
1 - 6 of 6 Posts
Top