Yellow Bullet Forums banner
1 - 1 of 1 Posts

· Registered
911 Posts
Discussion Starter · #1 ·
b/4 any1 starts i know this is not engine forum .my question on opinions is this :if a crank just say a cheaper more of a n/a only crankshaft is used for nitrous just say 3-400 hp can this bend or distort the integrity of the crank , and then in turn if not checked throughly before using again wipe out the bearings on the mains ??thanks in advance for your imput
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.