Yellow Bullet Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
911 Posts
Discussion Starter #1
b/4 any1 starts i know this is not engine forum .my question on opinions is this :if a crank just say a cheaper more of a n/a only crankshaft is used for nitrous just say 3-400 hp can this bend or distort the integrity of the crank , and then in turn if not checked throughly before using again wipe out the bearings on the mains ??thanks in advance for your imput
 
1 - 2 of 2 Posts
Top