Yellow Bullet Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
628 Posts
I used to repair cranks at a machine shop & we did any material even cast. The trick is the journal cannot be welded over the nitride treating so it must be roughed down. Usually we would go .080 & then hit the sides with the side of the wheel to open them up past it. Then weld it, straighten, grind & send out to get nitride treated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top