Yellow Bullet Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3,071 Posts
People are sneaking up on compression all the time nowadays. It depends on if it's fuel injected or carburated though. Fuel injection's more precise fuel control, can tolerate more compression. I was at 8.87 to 1, but my new pistons are going to put me about 10.5 to 1. I believe most people say about .037 piston to head with steel rods min.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top