Yellow Bullet Forums banner

1 - 13 of 13 Posts

·
Registered
Joined
·
2,994 Posts
Discussion Starter · #1 ·
What's the minimum compression height one can use for a power adder combination?

Is one power adder more forgiving with compression height, thus ring packaging than the others?

Perhaps lots of varibles to take into consideration, but thats why I'm asking.

Thanks in advance!
 

·
Registered
Joined
·
2,994 Posts
Discussion Starter · #2 ·
anyone want to give it a shot?
 

·
Registered
Joined
·
4,391 Posts
What's the minimum compression height one can use for a power adder combination?

Is one power adder more forgiving with compression height, thus ring packaging than the others?

Perhaps lots of varibles to take into consideration, but thats why I'm asking.

Thanks in advance!
What are you looking to build? I got engines with a 1.120 CH taking 500 shot of nitrous all summer long with a 12* head.
 

·
Registered
Joined
·
2,994 Posts
Discussion Starter · #5 ·
What are you looking to build? I got engines with a 1.120 CH taking 500 shot of nitrous all summer long with a 12* head.
Thanks guys for your answer.

I was just flirting with the possibilities of various engine sizes. ;) (fingers crossed behind back)
 

·
Diamond Pistons Rep
Joined
·
4,400 Posts
1.100 would be the tightest depending on the cylinder head !!!
 

·
Registered
Joined
·
13,889 Posts
you guys are lost . comprssion hight. Is the distance between .wrist pin .and deck.1.700 is what i have on my 632 .4.75 stroke. 6.65 rod. :smt102
 

·
Registered
Joined
·
13,889 Posts
So you have a 10.7 deck block eh? 1.700 CH???

Mike here works for Diamon Pistons. You think he might know what CH is?
I wich i had a 10.7 deck aslong as weight was not soooo bad I love a nice ring pack:smt083
 
1 - 13 of 13 Posts
Top