Can these K850 springs be used with a hydraulic roller on an SBC?

470 Views 2 Replies 2 Participants Last post by Willy Wonka, Jul 18, 2009

Willy Wonka

Discussion Starter · Jul 18, 2009

Can these be used with a hydraulic roller on an SBC?:

K-850 1.550 diameter double Silicon spring with dampner that is good on flat tappet camshafts with up to .630 valve lift.

135# @ 1.900 - 419# @ 1.250 - coil bind @ 1.160

Save

1 - 2 of 3 Posts

Willy Wonka

Discussion Starter · #3 · Jul 18, 2009

Will be a street/strip car... probably less than .550 lift and less than 6500 rpm. Looking at an aftermarket EFI setup for induction.

I have only played with mechanical rollers and flat tappet cams in the past, so this is all new to me.

Save

1 - 2 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.