Yellow Bullet Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
982 Posts
Discussion Starter #1
Anybody ever put one in? any special steps like drilling spindles/modifying column? i bought one used with everything, but don't have the installation instructions. Any insight is greatly appreciated!
 

·
Registered
Joined
·
982 Posts
Discussion Starter #2
put it in today, only special steps are to:

1.drill spindles to 1/2" with step bit

2. pull clip out of steering column so shaft can fit inside

fits well, lightweight, lots of adjustment. used it with stock K-member, a little tight to front edge of K-member, but fits well. for anyone considering it, i'd recommend it
 

·
Registered
Joined
·
3,020 Posts
Everything I have every gotten from Burkhart has been very well engineered and fit very well. They have their program together over there.
 

·
Registered
Joined
·
982 Posts
Discussion Starter #4
they were even cool on the phone after i told them i bought it used and didn't have instructions with it. Will definitely be getting some more stuff from them in the near future
 
1 - 4 of 4 Posts
Top