Yellow Bullet Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
6,312 Posts
I don't think you should hurt a rod on an average motor cause air still compresses unlike a liquid which will bend a rod no problem. Some hugh high compression monster with a light rod could do it. You sort of suggest by your limited comments this is a pump gas street motor so I'd think you got a decent chance it could be OK. I'd run a girdle on the thing to reduce the strain on the studs myself if you can't afford shaft rockers. You already proved they are seeing excessive stress. RM
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top