Yellow Bullet Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
So I have a bone stock 366 (yeahhhhh) that I put two t3/t4s on. In my 80 camaro. Yes. It is the worst big block ever. It was free. Can I run 10 psi without converting the carb to a blow through? Pretty sure I wouldn't want to and not sure how to go about setting the carb up. It's a Proform 750. (Not in picture)

 

·
Registered
Joined
·
18 Posts
Discussion Starter · #4 · (Edited)
After more thought my question was dumb. I'll have to build mine into a blow through (Which is fine). I am going to be running it with a methanol injection and a nitrous kit so the answer should have been obvious to me.
 

·
Registered
Joined
·
18 Posts
Discussion Starter · #5 ·
Biggest question is does it blow up? I'm betting no. And that will be both good and bad. I could have put the crank and rods into a .100 over 454 block I have to make a 447. But then I'd need different heads and I'd rather just enjoy this for what it is. Pretty sure with tall deck pistons I can blow off like a quarter of an inch and not even notice.
 
1 - 5 of 5 Posts
Top