Yellow Bullet Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
90 Posts
Discussion Starter · #1 ·
I have a weiand intake that I am trying to install on my 468 bbc and it hits the valvecover rails. I am running Brodix heads. Any suggestions, I think it's off to the machine shop to fix, intake is brand new. Thanks for any help.:confused:
 

·
Registered
Joined
·
477 Posts
I had the same problem on a small block, I took a grinder and beveled the intake my self. there was still only certain valve covers that would fit.
 

·
Procharged SBC Enthusiast
Joined
·
5,150 Posts
Find somebody with a bridgeport and cut the edge down on about a 45 degree angle and it should fit.
 
1 - 3 of 3 Posts
Top