Yellow Bullet Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
373 Posts
Discussion Starter #1
DO YOU SWAP IT FROM THE BOTTOM OF THE FILTER HOUSING OR FROM THE TOP CAUSE IT SEEMS TO POKE OUT A LITTLE UNTIL I SCREW THE BOTTOM PART OF THE HOUSING WHICH I FEEL IT BENDS THE FILTER. WLL IT MESS UP THE FILTER COULD SOME ONE SHED SOME LIGHT ONTHIS????:confused:
 

·
Registered
Joined
·
263 Posts
X2 ON CAPS

I don't want to sound like I'm bashung BG, haha, but I probably am. I've wasted two BG400 pumps because the BG5000 filter element restricted flow. After the pump seals started leaking, I took the filter out and could not blow through it. It was causing so much suction, it was pulling the shaft over and was rubbing the seal.

And yes, I had problems getting the end back on when I tried an aftermarket filter, BG filters went on with no problem.
 
1 - 3 of 3 Posts
Top