Yellow Bullet Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
298 Posts
Discussion Starter · #1 ·
I'm getting ready to put together a KB Olds motor, and I'd like to make the purchase of parts from one dealer/distributor so that I can hopefully save a little $ on the bottom line. ;)

Who would be good suppliers to contact/deal with?

The only one that I've been in contact with at this point is Shafiroff.
 

·
Registered
Joined
·
1,556 Posts
If your wanting to buy parts at a good price and your machine shop do the work, give Scott at Dynoflo a call,he has very good prices.
I bought a set of Oliver rods from Pete at dynoflo. Customer service was lacking! I finally called Oliver direct, spoke with Eddie and he drop shipped the rods to me. Pete DID apologize to me for delays. I should not have had to go over his head and deal direct with Oliver to begin with.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top