Yellow Bullet Forums banner

1 - 9 of 9 Posts

·
kenny crockett
Joined
·
1,362 Posts
Discussion Starter #1
Is it OK to weld the tabs on the side of the tube. Most of the time I see them on the top or bottom. Thanks for the help.
 

·
Registered
Joined
·
2,387 Posts
I usually weld them diagonally at roughly 31 degrees from plumb, vectoring away from the fulcrum...
 

·
Registered
Joined
·
3,751 Posts
LOL, I thought for sure this was some kind of spam message or something.

For the ARB tabs on the housing, yes you can weld them on the side of it too if thats where it needs to be.
 

·
kenny crockett
Joined
·
1,362 Posts
Discussion Starter #9
LOL, I thought for sure this was some kind of spam message or something.

For the ARB tabs on the housing, yes you can weld them on the side of it too if thats where it needs to be.
thanks for the info... I posted the thread.. got busy then come back to read it and said WTF............. THANKS GUYS FOR ALL THE HELP.........
 
1 - 9 of 9 Posts
Top