Yellow Bullet Forums banner
1 - 10 of 10 Posts

·
Registered
Joined
·
514 Posts
Discussion Starter · #1 ·
I am in a little bit of a pickle... I am in the process of building a billet runner intake manifold. I have the runners and flanges ready and now the welder that I thought was going to weld it up has backed out. I do not have the equipment to try it myself and need to find another high end aluminum tig welder. I am located just east of Syracuse New York and could really use some suggestions. Thanks
 

·
Registered
Joined
·
5,292 Posts
How close?
 

·
Registered
Joined
·
514 Posts
Discussion Starter · #5 ·
Well, someone I can drive to. I need to have the runner welded to the head flanges, then I can shear the rest of the plenum peices and have the top flange and plate cut on the water jet. After this I will need to take the parts back to them for final welding.
 

·
Registered
Joined
·
5,292 Posts
I got a guy down here but it's 2hours for you
 
1 - 10 of 10 Posts
Top