I have been comtemplating making them similar to the design used on the km series mitsubishi servo.I have the machines to do it but dont have the time.Until them,I will just install longer pins on the 2004r and washers between the cushion spring cover and pin on the 700r4 till I get around to it.
Adjustable servo pins for 700R4 & 200-4R
Check out these cool new parts.
1 - 2 of 17 Posts
Jake it is a good idea to use it as a tool like you said to find the correct length pin.I never thought of it that way.I use a drilled cover to get the information needed to select proper pin length.I think I mentioned this to you a few years ago.Care must be taken when using the shim to go under the big cushion spring in the 2004r because the more shims you have the less the cushion spring compresses befor the band is applied and this can cause upshift and downshift clunks and concerns.
1 - 2 of 17 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Yellow Bullet Forums
A forum community dedicated to drag racing drivers and enthusiasts. Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!
Full Forum Listing
Recommended Communities
