Yellow Bullet Forums banner

5" dump with 6.5" of room?

1377 Views 18 Replies 8 Participants Last post by  comp670
Hi guys anyone done a tight dump pipe like this before,is it possable?
Would it restrict or be too much heat on the bend?
Any idea's...Thanks,

See less See more
1 - 3 of 19 Posts
its a pain in the ass, but can be done. probably going to have to cheat cut a bend a little bit, or even pie cut it.

do not use aluminum for a tight bend off the turbo like that.
whats a 5" stainless doughnut cost? gotta be big bucks id imagine lol
oops i miss read what you said. you said 5" on 5" center line, i just assumed it was a doughnut!

i had to make one of those "style" downpipes on friday in 3". its a pain. take forever to weld too, i always allow the metal to cool before i move to the next spot.
1 - 3 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.