Yellow Bullet Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,165 Posts
Discussion Starter #1
I just assembled the pump and for this trans and noticed this o-ring on the bench. There is a new one in my kit so it has to go somewhere, but for the life of me I'm not sure where. I went through the astg manual and it didn't jump out at me. Doesn't help that I took this apart over a year ago haha. Who can help me out?

It looks like a combination of a round o-ring and flat rubber washer if that makes sense.
 

·
Registered
Joined
·
19,284 Posts
Ck your pump bolts, could be one of the seals that goes under the head of
the pump bolt-looks to be about 1/4" inside diam.
 
1 - 4 of 4 Posts
Top