Yellow Bullet Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hello, I was curious as to what people thought of my combo and my ideas for change. What I have is as follows:
468 10:1
990 heads that have some bowl/chamber work and 2.25/1.88s
Dart single plane w/950 QFT carb
2" headers
Crower cam 270/276 @ .050 and .678 .661

The crank and rods (7/16) are stock so I'm afraid to take it much further than 7500rpms.

This is a 6 speed car, so when I take it to the track, ET is not really my focus. I look for MPH more than anything. I want the car to run good at highway speeds, but also it would be nice if it didn't feel like a 2 stroke when the power comes on at 4500. From what I gather, a Victor Jr. would be a better intake, so I plan to change that out at some point. My question is whether changing to the cam listed below will slow the car down. My thought is that I don't have enough compression or rpms for my current cam.

Crower 260/270 @ .050 and .651 .677

One reason I am looking at this cam is that it calls for the same springs the other cam does, and my budget is very tight right now. Should I save my money for a custom, or will the above be a good selection. Any and all comments/ideas are welcome.

Here is what the car ran last week:
60' - 1.90 <-- tires are worn
1/8th - [email protected]
1/4 - [email protected]

I would love to see 130+mph

Thanks,
Todd
 
1 - 1 of 1 Posts
Top