Yellow Bullet Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
1,028 Posts
Discussion Starter #1
I have a ford svo "W" block that is at 4.160. Now this is a fresh bore and deckplate hone to 4.160. Ford said it was good to 4.125.

Is it junk or not? Looking to sell it and not sure if it is worth it or not.
 

·
Registered
Joined
·
10,234 Posts
I have a ford svo "W" block that is at 4.160. Now this is a fresh bore and deckplate hone to 4.160. Ford said it was good to 4.125.

Is it junk or not? Looking to sell it and not sure if it is worth it or not.
so are you looking to sel it? or buy it from someone?
 

·
Registered
Joined
·
1,028 Posts
Discussion Starter #5
I am looking to sell it. I just dont want to sell something that is junk. Hell it has been a good block. I just put $200 in the bore job. I just dont know what it is worth. I am picking it up in a few hours. He siad he sonic checked an had the specs there. He told me it would be fine?
 

·
Registered
Joined
·
1,415 Posts
the only way to know for sure is to sonic check it. mine was the thinnest at #1 by the waterpump bolts. bore is at 4.135".
 
1 - 8 of 8 Posts
Top