I am in the midst of picking rotating mass for 347 stroker. Already have Scat crank. Have selected 5.4 rods and all that is left is piston selection. There are 2 pin sizes available. .912 and .927. Is there an advantage to either one or any disadvantages?
Posts by woofie131
1 - 5 of 9 Posts
Oh yeah, this motor is being fed by a Novi 2000, hence my question in this area of the Bullet.
Thank you BigD. Where are you in Ky? I'm 5 miles from the "Valley".
Probe pistons using older set of Canfield's
Sounds good. Thanks Grunt.
1 - 5 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Yellow Bullet Forums
A forum community dedicated to drag racing drivers and enthusiasts. Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!
Full Forum Listing
Join now to ask and comment!
