Yellow Bullet Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
283 Posts
Discussion Starter · #1 ·
I made a stupid ass mistake the last race of the season and did not fill my rear end with fluid. I made two passes and the pinion locked up tight. I am having a real hard time getting the pinion to release from the bearing so I can rebuild the rear end. Does anyone have any ideas on something that may help release the outer bearing from the pinion shaft. I have beat on the pinion with a hammer for probably a good thirty minutes and it will not release. Anyonever had this happen before, I am running out of ideas and need to get this thing apart.
 
1 - 3 of 3 Posts
Top