whats the biggest single system you have used?

onefast68 · 05-13-2009, 09:11 PM

i have sprayed a 36pill with good results ..i am planning to try a 40pill tuneup for a grudge race where i can run big tires and 1 kit only...what have you tried and what were the results if you can say?

teamguss716 · 05-13-2009, 09:18 PM

40/36 5.11@142 615 conventional (afr ) headed bbc, stocksusp true 28x10.5

excelerater · 05-13-2009, 09:21 PM

63s in a fogger is the largest I heard of on a BBC....

Glen_Jones · 05-13-2009, 09:21 PM

42's on a small block. Swapped to the 42Nitrous jet fogger setup from about 250 on a plate at around 2960#----5.12@140.---No progressive, Just timing.

You could tell pretty well when the big kit came on.

Glen

Eric David Bru · 05-13-2009, 09:29 PM

Quote:

Originally Posted by excelerater

63s in a fogger is the largest I heard of on a BBC....

Was there anything left of the engine after this?

EDB

onefast68 · 05-13-2009, 09:30 PM

Quote:

Originally Posted by teamguss716

40/36 5.11@142 615 conventional (afr ) headed bbc, stocksusp true 28x10.5

good numbers for sure..what psi did it like on the fuel with a 40/36?

Sprayin96ta · 05-13-2009, 09:41 PM

Quote:

Originally Posted by excelerater

63s in a fogger is the largest I heard of on a BBC....

Monte Smith · 05-13-2009, 09:59 PM

Quote:

Originally Posted by Eric David Bru

Was there anything left of the engine after this?

EDB

This is one of my customers. Conventional headed 525. 3300 lbs, drag radials, stock suspension. Car has been a best of 7.94 with the .063s in the fogger. Last I heard, the motor had over 75 hits on this tune and has not hurt a part. NOS "soft plume" nozzles, "trashcan" nitrous solenoids and "cheater" fuel solenoids. Passes a little over 2800 lb/hr of nitrous.

Monte

TwinFoggerSBC · 05-13-2009, 10:07 PM

Quote:

Originally Posted by Monte Smith

This is one of my customers. Conventional headed 525. 3300 lbs, drag radials, stock suspension. Car has been a best of 7.94 with the .063s in the fogger. Last I heard, the motor had over 75 hits on this tune and has not hurt a part. NOS "soft plume" nozzles, "trashcan" nitrous solenoids and "cheater" fuel solenoids. Passes a little over 2800 lb/hr of nitrous.

Monte

Good stuff Monte

1nos68 · 05-13-2009, 10:07 PM

DAYUM Monte.......

Induction-Solutions · 05-13-2009, 10:27 PM

Will,
We have had quite a few customers in Extreme Street and Nost. Pro Street run .046 and .048 jets... I have also had a couple of guys run some .052 to .054 jets as well... Thanks, SJ

Mike Thompson · 05-13-2009, 10:36 PM

Quote:

Originally Posted by Induction-Solutions

Will,
We have had quite a few customers in Extreme Street and Nost. Pro Street run .046 and .048 jets... I have also had a couple of guys run some .052 to .054 jets as well... Thanks, SJ

Whoa! You mean there are 525's in ES that need a .054 to compete?

Induction-Solutions · 05-13-2009, 11:05 PM

Quote:

Originally Posted by Mike Thompson

Whoa! You mean there are 525's in ES that need a .054 to compete?

The combo with the .054's needed a litle more then just jet I think ???

SJ

teamguss716 · 05-13-2009, 11:20 PM

Quote:

Originally Posted by onefast68

good numbers for sure..what psi did it like on the fuel with a 40/36?

we ran between 4.75 to 5.25 on the fuel, on all 3 kits we ran a 4.92 @ 151 back in 2007,

first kit= 40/36
2nd= 38/34
3rd= 30/24

the motor never seemed to like the 3rd kit and was like a one pass wonder with it lol

onefast68 · 05-13-2009, 11:26 PM

Quote:

Originally Posted by teamguss716

we ran between 4.75 to 5.25 on the fuel, on all 3 kits we ran a 4.92 @ 151 back in 2007,

first kit= 40/36
2nd= 38/34
3rd= 30/24

the motor never seemed to like the 3rd kit and was like a one pass wonder with it lol

now thats a promod tuneup.LOL.

thanks for the reply.

05-13-2009, 09:11 PM	#1
onefast68 Senior Member Smoked another BBC Join Date: Nov 2005 Location: down south Posts: 2,923	whats the biggest single system you have used? i have sprayed a 36pill with good results ..i am planning to try a 40pill tuneup for a grudge race where i can run big tires and 1 kit only...what have you tried and what were the results if you can say? __________________ 68 camaro............................................ ........85 camaro street car big duke 632 with 2 kits ..................................598 with 360 heads w 1 kit 4.98 at 144.7 ...............................................8.9 5 at 154

05-13-2009, 09:18 PM	#2
teamguss716 Junior Member Spooled up Join Date: May 2008 Location: Asheville N.C Posts: 156	Re: whats the biggest single system you have used? 40/36 5.11@142 615 conventional (afr ) headed bbc, stocksusp true 28x10.5 __________________ 4.75@162 315s Jeremy McElrath www.teamguss.com

05-13-2009, 09:21 PM	#3
excelerater Senior Member Smoked Another SBC Join Date: Oct 2006 Location: Memphis,TN Posts: 6,900	Re: whats the biggest single system you have used? 63s in a fogger is the largest I heard of on a BBC.... __________________

05-13-2009, 09:21 PM	#4
Glen_Jones Junior Member Launchin Join Date: Mar 2007 Location: ALABAMA Posts: 393	Re: whats the biggest single system you have used? 42's on a small block. Swapped to the 42Nitrous jet fogger setup from about 250 on a plate at around 2960#----5.12@140.---No progressive, Just timing. You could tell pretty well when the big kit came on. Glen __________________ ORSCA EZ 126 F-2 Power 400" SBF 4.97 @145 Last edited by Glen_Jones; 05-13-2009 at 09:23 PM.

05-13-2009, 10:07 PM	#10
1nos68 Junior Member Launchin Join Date: Jun 2007 Location: Tyler Tx. Posts: 258	Re: whats the biggest single system you have used? DAYUM Monte....... __________________ Its not a ride without Oxide.......5.80 @120with a 357 SBC....9.09 @ 148@3140lbs

05-13-2009, 10:27 PM	#11
Induction-Solutions Moderator Smoked Another SBC Join Date: Sep 2007 Location: Florida Posts: 4,655	Re: whats the biggest single system you have used? Will, We have had quite a few customers in Extreme Street and Nost. Pro Street run .046 and .048 jets... I have also had a couple of guys run some .052 to .054 jets as well... Thanks, SJ __________________ Steve Johnson Please check out our forum at.... www.Induction-Solutions.com www.woodys-plumbing.com 815-341-8853 Cell 352-345-8010 Parts/Shop NOSMAN1@aol.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode