Yellow Bullet Forums banner

Buick 350 SB Stock Appearing Build Questions

800 views 4 replies 3 participants last post by  Crossbreed383 
#1 ·
Putiing together a stock looking 350 buick small block
Need to use factory manifolds due to no headers are available for my chassis(73 Apollo)
Just bought 1 owner 75k 73 Apollo
Looking to have fun with it as a driver with a little extra kick
Its an original 350 2 barrel car
I purchased a fresh 350 motor with converter from somebody that came with 2 cams
Wondering about cam choice and possible mods for these exhaust manifolds
Engine combo is
350 .030 over
3.900"stroke
TRW-10.5 compression forged pistons
Kenne Belle oiling mods
Mildly ported 68 factory heads w stock valve sizes(bowl heavily ported along with runner work and some chamber cleanup/deshrouding)
2-1/2 exhaust- mandrel bent w h-pipe and Dynomax Superturbos
T/A Performance aluminum dual plane with port matching and plenum work-1 in spacer
Modified 800cfm Quadrajet
3500 stall(came with engine)-TH 350 trans
3.73 gear
3400 pound car
I have 2 cams
1-Ultradyne -239-239 @050 530 lift 108 lobe sep +4
2-Erson cam-232-242@050-545 lift-112 lobe sep +4


Again id like to be able to use headers or maybe make a set down the road,but for now i assume that i will need to use the stock manifolds
This basic combo with the tight 108 cam ran mid 13s in Denver in a 3600 pd Skylark with same converter and addition of headers
Thanks
 
See less See more
#3 ·
i tried to register there but it wont ever send a activation email back?
 
#5 ·
I can keep trying
Maybe somebody with an account can messge a moderaotr for me?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top