Thy all fit the contour well.
DMC were a little light on extra material to go into the outer wheel wells.
Wolfe seemed good in the outer wheel well area.
But I like the Team Z ones best because they sent it with enough material to close off the inner portion of the frame rail as well as overlap into the wheel well.
They may all be similar enough now though. And I've used trunk hinges and springs with all of them.
I installed the team z tubs in my 93 gt and reworked everything to fit back around them. The tubs were simple, just take your time and cut small amounts and install again and again till you get the fitment you want. Seats and everything eles is a more time consuming. You can see my car here. http://www.yellowbullet.com/forum/showthread.php?t=184192&page=76
I have the Wolfe, had them shipped already assembled. The previous time I did not and it was a major pain to put that seam together. Very nice kit, comes with the notch plates too.
^^what is your plan for a barrier to the hatch? Looks good!
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Yellow Bullet Forums
23.7M posts
139.3K members
Since 2005
A forum community dedicated to drag racing drivers and enthusiasts. Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!