Yellow Bullet Forums banner

mini tubbed foxes

1M views 2K replies 399 participants last post by  boosted363 
#1 ·
http://


http://


http://


http://


http://



the bimini blue and mineral gray one is mine and the crystal blue metallic coupe belongs to my good friend Jay from Nelson's body shop who did the chassis, body and paint on both cars. Enjoy! :-D
 
See less See more
5
#2 ·
hell yeah dude!! Those look killer!!! Both of them! What are the specs of the mini tubs, wheels, how much were the rears cut, etc.....
 
#9 ·
what are the back spacings???? any pics from the rear?? Again, badass!!
 
#11 ·
thanks bro! My car is apart right now and I just sold the wheels. I am getting ready to buy a new set but unsure if I want to mini tub it yet and if i should just go ahead and get the 10" with a 6.5 bs.
 
#278 ·
thanks bro! My car is apart right now and I just sold the wheels. I am getting ready to buy a new set but unsure if I want to mini tub it yet and if i should just go ahead and get the 10" with a 6.5 bs.
got a set of prostars that I can hook you up with they have a pair of 315 m/t radials on them 10 inch 5 0n 4.5 6.5 back space.
 
#15 ·
Almost looks like the 12" rim makes the tire wider. I am in the middle of this same project using wolfe mini tubs, and had the 9" shortened 2.5" on each side. when you find out the back space on the 12s for sure could you post that please.
Was leaning towards the billet specialties myself now I know they are for me.
Cars look fantastic, thanks for sharing and keeping me geared up on my project.
 
#20 ·
15X8 w/ 5.5 w/275's
15X10 w/6.5 w/325's

Minitub, coil overs, + narrowed rear by Tony's Metal Crafts











Roy Williams GT also done by Tony's Metal Crafts
15X12 w/ 28X13X15's

 
#21 ·
I'll throw a few pics into the pot...

9" narrowed 2" ea. side from stock width, notched frame rails,
Coilovers w/ Outlaw style Ladder Bars...

15x12's w/ 6" bs 29.5x10.5's



15x11's w/ 5.5" bs 315/60's

 
#25 ·
Here's Mine. Team Z 9inch narrowed about two+ inches each side. Stock Suspension setup. Has 15x10 Alumastars with 6 inch BS double beadlocked. With 295's for now. 275's going on for next year .
All Motor 406 SBF Brodix Neal's/Glide. been 9.68 @ 140 on the brakes with the chute out trying not to break out.
Been 144.90mph blowing the tires off running a 2.0 60ft and 10.00. had to pedal it. Should be in the 9.20/30's at close to 148 on a good hit. Hopefully tomorrow.

Dan Smith



 
#28 ·
Yes you will have to trim the fender on the 315 on all the ones i have seen, unless you have quite the narrow rear and deep backspace I guess..


Nick Edelmans in progress hatch w/ narrowed 9" moser m9/coil over- 315 MT radial on 15X12 wheel with some wheelwell reshaping by Rob "rookie" Meyers





 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top