Yellow Bullet Forums banner

nos wiring components

2K views 3 replies 3 participants last post by  69yenko 
#1 ·
Mike, I am installing a single stage fogger and have a few questions about recommended parts and wiring. Can I use p/n MSD-8960 DPST 30amp relay for the fuel and nos solenoids with the fuel on one side and the nos on the other. Also do you use fusible links or fuse holders between relay and solenoids. And finally, what size wire is recommended for load wire from power source to relay to solenoid, and trigger wire from switch to relay. Thanks Troy
 
#3 ·
Troy,
The Relay you listed would work fine for your application, you could also get away with running the MSD-8961. You should fuse either the Power side of the relay (Pin 30) or the output side to the Solenoids (Pin 87).
As for Wire size to the solenoids, bigger is always better. Something in the 14 to 12 Gauge wire size should more then get the job done. On the trigger side of the relay, 18 gauge wire works very well.

I hope this helps,
Sparky
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top