Put a turbo 400 in sons nova and it worked fine for like 2 months then it just stopped going into 3rd? it stays in 2nd and no matter how high u take rpms up it will not shift ...
any Ideas what i need to look for check ?
we now have it out of car:smt100
If its un hooked it wont down shift(passing gear) I have seen the valve go bad an that make the transmission stay in second(passing gear) When u open that port on the valve body your in second. block the port of on u should get the up shift back
Well it doesn't have cable to carb but does have a electric hookup on linkage side near rear of trans that i hooked nothing to ? so i am not sure what your saying to do ?
Swap out the silnoid valve in side the pan the valve is leaking through. Drop the pan take out two small bolts unplug an put it a different one. Or block it of with flat bar. Yours is most likely bad. Stuck open. Its like its trying to down shift all the time. It happens had it happen on a freshs trans
Take it apart and check the high clutch and sealing rings. The first stage of repair should be inspecting the internals while its out.
Hutch
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Yellow Bullet Forums
23.7M posts
139.6K members
Since 2005
A forum community dedicated to drag racing drivers and enthusiasts. Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!