Hi Brillko! I'm Rob and I have an issue with my Holley Dominator EFI. I've seen that you are the man with this. If have the time and willing to help me I would be thankful. The issue is that it has no trigger to the ignition or to injectors. My red wire on the fuel injector connector is reading 3.3 volts as well as the fuel pump green wire. Thinking maybe my main harness relay? I have a crank trigger with magnetic sensor but have the halleffect sensor as well. Tried both. the can sync is a MSD distributor with the 7 of the 8 reluctors removed and made it phasable. Crank is set to 60 btdc and the can is set 195 btdc. Cam is using the magnetic pickup as well. I tried with a 12 volt and 16 volt batter to see if made any difference. It did not. Not sure if have wired up something wrong or if something else is wrong. I have no rpm reading while cranking.