Yellow Bullet Forums banner

Reaction score
3,121

Marketplace Rating
(0.0 - 0 reviews)

Profile posts Latest activity Discussions Buy & Sell Reviews About

  • · Registered
    Joined
    ·
    6,853 Posts
    615 BBC, Dart block, RFD 24 degree pro heads, port matched SV 632 intake, 55 MM Straub custom solid roller, .904 Morels, T&D shaft rockers, 11.1 flat top diamond piston, Callies magnum crank, and Callies ultra rod, external Peterson oil pump.

    · Registered
    Joined
    ·
    3 Posts
    Hi, Saw your post and wanted to reply about your combo, 9.0 on pump gas! I'm wondering if you could tell me a liitle more about your engine combo. I'm running 10.0@135 in my 3800 lb 72 chevelle which has my 9.5 comp hyd roller cammed 598 from my boat in it. Going to reconfigure it and was looking for pump gas combos. Thanks for your help! Holden

    · Registered
    Joined
    ·
    6,853 Posts
    Coilovers would imply you are running shock with coil spring. Which is it....coilovers or shock and cal-tracs?

    · Registered
    Joined
    ·
    13 Posts
    Saw your post in the anti roll bar one and I'm wondering how you setup your rear shocks/coilovers. I'm getting the trz arb and run coilovers in the rear with caltracs but I want to run the shocks vertical inboard

    · Registered
    Joined
    ·
    0 Posts
    Hey bud seen some of your postings on here and saw your videos on you tube with the 598
    Love the car man and the engine. I had a few questions for you can't find a whole lot of people
    Around my area that knows much about the tall deck deal. I'm getting ready to build me a new engine and wondered how you liked your 598 on the street. Say vs a 540 short deck deal.

    · Registered
    Joined
    ·
    25 Posts
    Hi Biglar,this is RootBeer out off humble tx.I was following the build on the cage work in your car,I thinks its 25.5 or so ?Well I need a chassis guy to install 25.5 cage in 55 chevy 210,any info would be greatly appreciated..thanks

    · Registered
    Joined
    ·
    6,853 Posts
    Still have the car. Car has been 9.48 @ 142. Drives straight down the track. Had some set backs with the trans. Still tunning on the car as well. Car is set up for the gas. Still saving to get all those things done. Over all very satisified with the car.

    · Registered
    Joined
    ·
    22 Posts
    Not sure if you still have the car but how is that spring and caltracs working for you? Mine is almost in the same location and curious it its needs to be moved. Thanks Kevin.

    · Registered
    Joined
    ·
    6,853 Posts
    I have a chassis guy doing most of the work. I would have loved to have done it myself however I have never welded crome moly.

    · Registered
    Joined
    ·
    0 Posts
    Im building a 70 nova ss and I was wondering if you could tell me how you did your rack and pinion on your nova.
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top